欢迎您！东篱公司
退出
-
申报数据库
-
立项数据库
-
成果数据库
-
项目获奖数据库
中文摘要：
在Gleeble-1500热模拟机上对Ti-5Al-5Mo-5V-1Cr-1Fe合金进行高温热压缩实验,研究该合金在变形温度为750~900℃、应变速率为0.001~1 s 1条件下的流变应力行为。利用光学显微镜分析合金在不同变形条件下的组织演化规律。结果表明：合金的流变应力随着应变速率的增大和变形温度的降低而增大;流变应力随着应变的增加而增大,出现峰值后逐渐趋于平稳;变形过程中的流变应力可用Arrhenius双曲正弦本构关系来描述,平均变形激活能为454.2 kJ/mol;各种变形条件均可细化原始晶粒尺寸。随着温度的升高和应变速率的降低,合金的主要软化机制由动态回复逐渐变为动态再结晶;在（α＋β）相区变形（750~850℃）时,α相对β晶粒的动态再结晶的发生起到阻碍作用。
英文摘要：
The hot deformation behaviors of Ti-5Al-5Mo-5V-1Cr-1Fe alloy were studied by a Gleeble-1500 machine at 750-900 ℃ with the strain rate of 0.001-1 s-1.The microstructural evolution of the alloy was investigated by optical microscopy.The results indicate that the flow stress of the alloy increases with increasing strain rate and decreasing deformation temperature.The flow stress increases with increasing strain until the stress reaches the peak value,then the flow stress remains constant.The flow stress in deformation can be described by Arrhenius hyperbolic sine constitutive equation,and the average activation energy is 454.2 kJ/mol.The original grain size can be refined under all deformation conditions.The main softening mechanism is changed from dynamic recovery to dynamic recrystallization with increasing the deformation temperature and decreasing the strain rate.In the（α＋β） region（750-850 ℃）,α phase can inhibit the dynamic recrystallization of β grains particles during deformation.
同期刊论文项目
同项目期刊论文
Osteoblastic cell response on biphasic fluorhydroxyapatite/strontium-substituted hydroxyapatite coat
Synthesis and optical property of ultra-long alpha-Si3N4 nanowires under superatmospheric pressure c
A thermodynamic description of the Co-Cr-Ti ternary system over the entire composition and temperatu
Development of an atomic mobility database for disordered and ordered fcc phases in multicomponent A
Thermodynamic description of the Al-Mg-Si system using a new formulation for the temperature depende
Experimental Investigation and Computer Simulation of Gradient Zone Formation in WC-Ti(C,N)-TaC-NbC-
Photosan-II loaded hollow silica nanoparticles: Preparation and its effect in killing for QBC939 cel
Effect of calcium on the electrochemical behavior of lithium anode in LiOH aqueous solution used for
Facile synthesis of Ag/AgVO3 hybrid nanorods with enhanced electrochemical performance as cathode ma
Thermodynamic description of the Ge-Na and Ge-K systems using the CALPHAD approach supported by firs
Investigation to impurity content and micromorphology of high purity titanium powder prepared by mol
Microstructures and mechanical properties of Fe-14Cr-3W-Ti-Y2O3 steel with 1 wt.% Cu addition fabric
Ideal mechanical strength and interface cohesion property of Ir-base superalloys from first principl
Effect of MWCNTs Additive on Desorption Properties of Zn(BH4)(2) Composite Prepared by Mechanical Al
Effects of Ca on microstructure, mechanical and corrosion properties and biocompatibility of Mg-Zn-C
Microstructural Evolution of a Nickel Ferrite-Copper Alloy Cermet During Sintering and High-Temperat
Innovative processing of high-strength and low-cost ferritic steels strengthened by Y-Ti-O nanoclust
Effect of tungsten content on microstructure and quasi-static tensile fracture characteristics of ra
Synthesis and characterization of superhydrophobic functionalized nanoparticle arrays on aluminum su
Preparation of Super-Hydrophobic Aluminum by a Novel Immersion Method using Potassium Permanganate S
Structural evolution and ablation mechanism of a hafnium carbide coating on a C/C composite in an ox
Experimental investigation and thermodynamic modeling of the Cu-Si-Zn system with the refined descri
THERMODYNAMIC MODELING OF THE Fe-Zn SYSTEM USING EXPONENTIAL TEMPERATURE DEPENDENCE FOR THE EXCESS G
Relationship between lamellar alpha evolution and flow behavior during isothermal deformation of Ti-
Effect of heat treatment on strength, exfoliation corrosion and electrochemical behavior of 7085 alu
First-principles calculations of binary Al compounds: Enthalpies of formation and elastic properties
Structure and thermodynamics of the key precipitated phases in the Al-Mg-Si alloys from first-princi
Development of an atomic mobility database for liquid phase in multicomponent Al alloys: focusing on
Fiber/matrix interfacial shear strength of C/C composites with PyC-TaC-PyC and PyC-SiC-TaC-PyC multi
Sol-hydrothermal synthesis and optical properties of Eu3+, Tb3+-codoped one-dimensional strontium ge
Flower-like hydroxyapatite modified carbon paste electrodes applicable for highly sensitive detectio
Comparison of microstructure and mechanical properties of Co-based and Fe-based alloy coatings depos
Thermodynamic assessment of the Ga-X (X=B, Ca, Sr, Ba) systems supported by first-principles calcula
Effect of heat treatment on hot deformation behavior and microstructure evolution of 7085 aluminum a
Ablation behavior of HfC protective coatings for carbon/carbon composites in an oxyacetylene combust
Effects of partial hydrogenation and vacancy defects on the electronic properties of metallic carbon
Effects of Cu and Al on the crystal structure and composition of eta (MgZn2) phase in over-aged Al-Z
Conversion of egg-shell to hydroxyapatite for highly sensitive detection of endocrine disruptor bisp
期刊信息
位置：