位置:成果数据库 > 期刊 > 期刊详情页
MSM结构ZnO紫外探测器的制备与性质
  • ISSN号:1000-7032
  • 期刊名称:发光学报
  • 时间:0
  • 页码:1361-1369
  • 语言:中文
  • 分类:O472.8[理学—半导体物理;理学—物理]
  • 作者机构:[1]中国科学院长春光学精密机械与物理研究所激发态物理重点实验室,吉林长春130033, [2]长春理工大学高功率半导体激光国家重点实验室,吉林长春130022
  • 相关基金:基金项目:国家重点基金(50532050);国家“973”计划(2008CB307105,2006CB604906);国家自然科学基金(60676059,60506014);教育部新世纪优秀人才支持计划(NCET-07-0122)资助项目
  • 相关项目:稳定、高效的p型ZnO薄膜的制备及器件研究
中文摘要:

采用射频磁控溅射在石英衬底上制备了c轴择优取向的ZnO薄膜,利用蚀刻技术制备了MSM结构的光导型紫外探测器。在3V偏压下,器件的暗电流小于250nA,光响应峰值在370nm,响应度是0.34A/W。其紫外(360nm)与可见光(420nm)的抑制比为4个数量级。器件的光响应时间上沿仅为20ns。

英文摘要:

In recent years, ultraviolet (UV) photodetector has drawn a great deal of interest, due to their potential application such as solar astronomy, fire alarm and combustion monitoring, missile plume detection, space-to-space transmission. Zinc oxide (ZnO) has large exciton binding energy (60 meV) at room temperature, and a large band gap at room temperature (3.37 eV), and low power threshold for optical pumping at room temperature, high electromechanical coupling factor and high stability under hard conditions, ZnO is recognized as promising material in the uhraviolet (UV) detectors. High quality ZnO films can be obtained by various deposition techniques such as radio frequency (rf) magnetron sputtering technique, pulsed laser deposition (PLD) , metalorganic chemical vapor deposition ( MOCVD), and also molecular beam epitaxy (MBE). Among these techniques,the operation of radio frequency magnetron sputtering technique is simply and lower cost. ZnO thin rims were grown on quartz substrates using radio frequency (rf) magnetron sputtering technique. Before sputtering, the quartz substrates were cleaned in an ultrasonic bath with acetone, ethanol and de-ionized water at room temperature and the zinc(99. 999% ) target was etched with diluted nitric acid to remove the contamination. The base pressure of sputtering chamber was evacuated to be below 5 × 10^-4 Pa, and then filled to 1.0 Pa with mixed gases of 99.99% pure Ar and O2 ,which were introduced into the sputtering chamber though a set of mass flow controllers with the rates of 60 and 20 sccm ( standard cubic centimeter perminute), respectively. The target-substrate distance was maintained at 50 mm and the substrate temperature was controlled at 400 ℃. The rate of deposition was adjusted so as to have a film thickness of nearly 400 nm during the film growth. The MSM structure with interdigitated configuration on the ZnO thin films was obtained by lithography and wet etching. It consists of 12 fingers at each electrod

同期刊论文项目
期刊论文 106 会议论文 7 专利 13
同项目期刊论文
期刊信息
  • 《发光学报》
  • 中国科技核心期刊
  • 主管单位:中国科学院
  • 主办单位:中国物理学会发光分会 中国科学院长春光学精密机械与物理研究所
  • 主编:申德振
  • 地址:长春市东南湖大路3888号
  • 邮编:130033
  • 邮箱:fgxbt@126.com
  • 电话:0431-86176862
  • 国际标准刊号:ISSN:1000-7032
  • 国内统一刊号:ISSN:22-1116/O4
  • 邮发代号:12-312
  • 获奖情况:
  • 物理学类核心期刊,2000年获中国科学院优秀期刊二等奖,中国期刊方阵“双效”期刊
  • 国内外数据库收录:
  • 美国化学文摘(网络版),荷兰文摘与引文数据库,美国工程索引,美国剑桥科学文摘,日本日本科学技术振兴机构数据库,中国中国科技核心期刊,中国北大核心期刊(2004版),中国北大核心期刊(2008版),中国北大核心期刊(2011版),中国北大核心期刊(2014版),中国北大核心期刊(2000版)
  • 被引量:7320