位置：成果数据库 > 期刊 > 期刊详情页
高压扭转铜试样的微观组织与压缩性能
  • 期刊名称：谢子令，武晓雷，谢季佳，洪友士. 高压扭转铜试样的微观组织与压缩性能.《金属学报》(2008), V
  • 时间：0
  • 分类：TG146.1[金属学及工艺—金属材料;一般工业技术—材料科学与工程;金属学及工艺—金属学]
  • 作者机构：[1]温州大学建筑与土木工程学院,浙江温州325035, [2]中国科学院力学研究所非线性力学国家重点实验室,北京100190
  • 相关基金：国家自然科学基金项目（10721202 10772178 50571110）
  • 相关项目：材料强度及灾变的跨尺度力学研究
关键词： CU, 高压扭转, 微观结构, 显微硬度, 扭转速度, copper, high pressure torsion（HPT）, microstructure, microhardness, revolution speed
中文摘要：

通过高压扭转（HPT）技术在不同转速条件下实现了Cu试样的晶粒细化。利用光学显微镜（OM）、透射电镜（TEM）及显微硬度计观察并测试了组织的结构与性能,并基于有限元计算了变形诱导试样的温升,研究了转速对Cu试样的组织细化与性能的影响。结果表明：转速由1/3r.min-1增大至1r.min-1,经1圈扭转变形,试样温度由40.8℃升高到54.1℃,变形组织均为100～600nm的高位错密度位错胞/亚晶组织,显微硬度由初始态的52HV0.05增大至140HV0.05;经16圈扭转变形,试样温度由50.4℃升高到97.4℃,组织细化到200nm。慢速扭转变形试样晶内位错密度高,微观组织处于严重变形状态;而快速扭转试样晶内衬度均匀,位错较少,微观组织经历明显的动态回复,显微硬度较慢速扭转变形试样低6%。

英文摘要：

Cu specimens were deformed by high-pressure torsion（HPT）at different revolution speeds,to investigate the effect of revolution speed on its microstructure and mechanical properties by means of OM,TEM and microhardness testing.It was found that heavily deformed microstructure with average grain size in 200 nm formed in the sample after HPT deforming to large strains at a revolution speed of 1 /3 r.min-1.Increasing revolution speed up to 1 r.min-1,some dislocation-free fine grains appears,leading to a 6 percent of decrease in average hardness as compared to the lower revolution speed counterparts.One turn of HPT deformation induces dislocation-cells /subgrains with size in 100—600 nm formed and an increase in hardness from 52 to 140 HV0.05.The evolution of the microstructure and mechanical properties with revolution speed was interpreted by using a thermal analysis simulation based on heat generation induced by the extensive HPT deformation.

同期刊论文项目
材料强度及灾变的跨尺度力学研究
期刊论文 168
微细化纳米化表层的金属材料微结构和力学性能表征
期刊论文 15
低合金钢超高周疲劳若干基本问题的实验研究
期刊论文 15 会议论文 13
亚稳态超细/纳米晶粒组织的塑性变形机制与力学性能
期刊论文 15 会议论文 1 专利 1
同项目期刊论文
高压扭转Cu试样微观组织的热稳定性分析
Nanostructured metals: Less is more
Microstructures and compression properties of copper specimens deformed by high-pressure torsion
Inverse grain-size effect on twinning in nanocrystalline Ni
New deformation twinning mechanism generates zero macroscopic strain in nanocrystalline metals
Internal Friction of Bend-Deformed Nanocrystalline Nickel by Mechanical Spectroscopy
Study on fatigue crack nucleation of electrodeposited nanocrystalline nickle
Work softening and annealing hardening of deformed nanocrystalline nickel
Phase transformation accommodated plasticity in nanocrystalline nickel
具有梯度结构表层301不锈钢的压缩性能
Deformation twin formed by self-thickening, cross-slip mechanism in nanocrystalline Ni
Deformation twinning in bulk nanocrystalline metals: Experimental observations
微纳米晶金属的应变率敏感性及应变硬化行为分析
纳米晶Ni疲劳行为的实验研究
水介质和 3.5%NaCl 水溶液对 40Cr 结构钢 高周和超高周疲劳行为的影响
纳米晶镍疲劳行为的实验研究
合金材料超高周疲劳行为的基本特征和影响因素
环境介质对40Cr结构钢高周和超高周疲劳行为的影响
高压扭转Cu试样微观组织的热稳定性分析
Investigation of high cycle and Very-High-Cycle Fatigue behaviors for a structural steel with smooth
Influence of processing temperature on microstructure and microhardness of copper subjected to high-
转速对高压扭转Cu 试样的组织与性能的影响
纳米晶材料变形行为的微观力学分析
利用迹线测量晶体材料中特征面取向的EBSD 方法
利用迹线测量晶体材料中特征面取向的EBSD方法
加卸载响应比方法在结构灾变预测中的应用
Deformation Twinning Generates Zero Macro-Strain in Nanocrystalline Metals
Molecular dynamics study of mechanical behaviour of screw dislocation during cutting with diamond ti
Scaling function in conical indentation in elastic plastic solids
Twinning partial multiplication at grain boundary in nanocrystalline fcc metals
Plastic deformation of nanocrystalline nickel
Local Bending of a Thin Film on Viscous Layer
Extracting Nanobelt Mechanical Properties from Nanoindentation
Peeling behavior of a bio-inspired nano-film on a substrate,
Dynamic behaviors of mode III interfacial crack under a constant loading rate,
Enhanced Thermal Shock Resistance of Ceramics through Biomimetically Inspired Nano?ns
Load-Unload Response Ratio and its application to estimate future seismicity of Qiandao-lake region
Discussion on the contact width in generalized plain strain JKR model for isotropic solids
Strain gradient theory bsed on a New framework of non-local model
ANALYSIS OF THE THERMAL STABILITY OF COPPER SPECIMENS DEFORMED BY HIGH-PRESSURE TORSION
On mechanical properties of metallic glass and its liquid vitrification characteristics
Basic mechanical behaviors and mechanics of shear banding in BMGs
The capillary force in micro and nano-indentation with different indenter shapes
Damage assessment and preservation of suspending system of Yongle-Big-Bell
The main factor influencing the tensile properties of surface nano-crystallized graded materials,
Adhesive models to understand the sensitivity of bio-molecules to environmental signals
Tensionless contact of a finite beam resting on Reissner foundation
Growth mechanism and joint structure of ZnO tetrapods
Smaller Deborah number inducing more serrated plastic flow of metallic glass.
Numerical and theoretical investigations of the tensile failure of shrunk cement-based composites
纳米晶Ni疲劳行为的实验研究
The peak point of LURR and its significance， Concurrency and computation, Practice and Experience,
Critical Biot’s number determines the sensitivity of spherical ceramics to thermal shock
Dislocations and twins in nanocrystalline Ni after severe plastic deformation: the effects of grain
Transitions between different contact models
Strong Strain Hardening in Nanocrystalline Nickel
Eigenfrequency Computation of Beam/Plate Carrying Concentrated Mass/Spring and Its Application to Re
Elastic deformation of soft membrane with finite thickness induced by a sessile liquid droplet.
Precursor film in dynamic wetting, electrowetting and electro-elasto-capillarity.
Nanoscale periodic corrugation to dimple transition due to “beat” in a bulk metallic glass
Orientation-dependent adhesion strength of a rigid cylinder in non-slipping contact with a transvers
Mechanical Behavior of Nanometer Ni by Simulating Nanoindentation
Effect of Water on Brittle Fracture of SiO2 by Molecular Dynamics
Mixed mode failure of interface between metal film and ceramic substrate in peel test
Energy dissipation in fracture of bulk metallic glasses via inherent competition between local soft
Dynamic fracture instability of tough bulk metallic glass
Static and Dynamic Structural Modeling Analysis of Atomic Force Microscope
Response to "Comment on 'Deformation mechanisms of face-centeredcubic metal nanowires with twin boun
Evolution of localized damage zone in heterogeneous media
A simple method to simulate shrinkage-induced cracking in cement-based composites by lattice-type mo
New Strain Gradient Theory and Analysis
纳米晶 Ni 晶间断裂的数值模拟
合金材料超高周疲劳行为的基本特征和影响因素
环境介质对40Cr结构钢高周和超高周疲劳行为的影响
Role of vertical component of surface tension of the droplet on the elastic deformation of PDMS memb
Ab initio study of ZnO based gas sensing mechanisms: Surface reconstruction and charge transfer.
Electrowetting on a lotus leaf
Shape effects on the yield stress and deformation of silicon nanowires: A molecular dynamics simulat
Adsorption of formaldehyde molecule on the intrinsic and Al-doped graphene: A first principle study.
A unified guide to two opposite size effects in nano elastic materials,
A Thin Liquid Film and Its Effects in an Atomic Force Microscopy Measurement,
Universal Biot number determining the stress duration and the susceptibility of ceramic cylinders to
An Elasto-plastic Damage Constitutive Theory Based on Pair Functional Potentials and Slip Mechanism,
Trans-scale mechanics – looking for the missing links between continuum and micro/nanoscopic reality
A method to determine fracture toughness using cube-corner indentation.
Molecular/cluster statistical thermodynamics methods to simulate quasi-static deformations at finit
Formation of Single and Multiple Deformation Twins in Nanocrystalline fcc Metals
Universal Biot number determining stress duration and susceptibility of ceramic cylinders to quenchi
An extension of the two dimensional JKR theory to the case with a large contact width
Determination of plastic properties by instrumented spherical indentation:Expanding cavity model and
Damage evolution induced catastrophe and its significance in forecasting terrestrial disasters
A comparative study of Young’s modulus of single-walled carbon nanotube by CPMD, MD, and first princ
MECHANISMS UNDERLYING TWO KINDS OF SURFACE EFFECTS ON ELASTIC CONSTANTS
Grain refinement of pure Ti during plastic deformation
Analytical method of predicating the instabilities of a micro arch-shaped beam under electrostatic l
Size-dependent adhesion strength of a single viscoelastic fiber
Deformation of PDMS membrane and microcantilever by a water droplet: Comparison between Mooney- Ri
Failure process analysis of cement under explosive loading with a generalized driven nonlinear thres
Atomistic simulation on size-dependent yield strength and defects evolution of metal nanowires.
First principles based predictions of the toughness of a metal/oxide interface
Alternating starvation of dislocations during plastic yielding in metallic nanowires
Numerical study of pile-up in bulk metallic glass during spherical indentation
高压扭转Cu试样微观组织的热稳定性分析
纳米晶材料变形行为的微观力学分析
有限变形下的后继屈服面演化规律研究
美国西部地区加卸载响应比的时空演化及地震活动性分析
加卸载响应比与损伤变量关系研究
地震条件下损伤-愈合模型的初步研究
具有梯度结构表层301不锈钢的压缩性能
On the contact width in generalized plain strain JKR model for isotropic solids
基于球形压入法提取材料的塑性力学参数
Trans-scale mechanics: looking for the missing links between continuum and micro/nanoscopic reality
Simulations of Mechanical Behavior of Polycrystalline Copper with Nano-Twins
一类蚂蚁黏附系统的实验研究
微纳米尺度下材料性能多尺度模拟方法进展
加卸载响应比——地震预测与力学的交叉
纤维复合材料刚度设计的力学原理及其应用
Inverse analysis determining interfacial properties between metal film and ceramic substrate with an adhesive layer
金属薄膜单轴拉伸过程中的等效性能研究
构元组集损伤断裂模型及其与内聚区模型的比较
汶川8级地震前加卸载响应比的大尺度异常
汶川余震序列的加卸载响应比分析
固体灾变性破坏现象
纳米晶Ni晶间断裂的数值模拟
DETERMINATION OF INTERFACIAL MECHANICAL PARAMETERS FOR AN Al/EPOXY/Al2O3 SYSTEM BY USING PEEL TEST SIMULATIONS
An Elasto-plastic Damage Constitutive Theory Based on Pair Functional Potentials and Slip Mechanism
三轴围压下砂浆弹塑性损伤变形过程的细观力学分析
Twinning in nanocrystalline Ni
Martensite transformation and
Deformation twinning in nanocr
Nanocrystalline formation duri
Fractography and crack initiat
Strain-induced grain refinemen
Shear bands at the fatigue cra
Micromechanics modelling of st
Localized solid-state amorphiz
微纳米晶金属的应变率敏感性及应变硬化行为分析
确定ZnO颗粒生长方向的电子背散射衍射方法
高能气动喷丸致纯铜细晶化的实验与模拟
高压扭转致纯铜晶粒细化及与应变的关系