欢迎您！东篱公司
退出
-
申报数据库
-
立项数据库
-
成果数据库
-
项目获奖数据库
中文摘要：
采用热轧制备晶粒尺寸为0.1~0.5μm超细晶Ti-55511近β钛合金,利用SEM、TEM等手段研究热处理工艺对超细晶合金显微组织和力学性能的影响。结果表明,在350~650℃的温度条件下,合金强度和硬度随温度的增加呈现先增高后降低的趋势,在450℃达到峰值1486 MPa;在450℃温度退火时,随着退火时间的延长,合金强度首先急剧上升至1536 MPa后趋于稳定,延伸率呈现先增加后下降的趋势。显微组织分析表明,合金在退火过程中主要发生回复现象,未发生明显的粗化长大现象,晶粒尺寸均〈1μm。回复过程在消除加工硬化的同时促进了晶界/相界的稳定化,提高细晶强化作用;退火过程中发生的α→α2和β→ω→α相变过程,第二相粒子弥散强化效应增强。但是当第二相粒子尺寸增加至一定尺寸时,会显著降低合金的塑性。退火过程中合金力学性能的变化与强化机制的作用有关。
英文摘要：
The ultra-fine grained（UFG） Ti-55511 near β titanium alloy with grain size 0.1~0.5 μm was prepared by hot rolling. The effects of heat treatment on the microstructure and mechanical properties were investigated using SEM and TEM. The results indicate that both strength and hardness increase firstly and then reduce with increasing of heat treatment temperature from 350 ℃ to 650 ℃. The peak strength（1486 MPa） appears at 450 ℃. The strength dramatically reaches to 1536 MPa and then is stablized with increasing of the holding time when heat treated at 450 ℃. While the elongation increases firstly and then decreases. The microstructure analysis shows that the dynamic recovery occurs and the grain sizes remain at smaller than 1 μm during annealing. The recovery stimulates the grain refinement effect by eliminating the hardening process and stimulating the grain boundary/phase boundary to be stable. The phase transformation of α→α2 and β→ω→α enhances the second phase particle dispersion effect during annealing. However, the ductility of the alloy could significant decrease when the second phase particles grow up to a certain size. The mechanical properties evolution during annealing are mainly related to the effect of strengthening mechanisms.
同期刊论文项目
同项目期刊论文
Osteoblastic cell response on biphasic fluorhydroxyapatite/strontium-substituted hydroxyapatite coat
Synthesis and optical property of ultra-long alpha-Si3N4 nanowires under superatmospheric pressure c
A thermodynamic description of the Co-Cr-Ti ternary system over the entire composition and temperatu
Development of an atomic mobility database for disordered and ordered fcc phases in multicomponent A
Thermodynamic description of the Al-Mg-Si system using a new formulation for the temperature depende
Experimental Investigation and Computer Simulation of Gradient Zone Formation in WC-Ti(C,N)-TaC-NbC-
Photosan-II loaded hollow silica nanoparticles: Preparation and its effect in killing for QBC939 cel
Effect of calcium on the electrochemical behavior of lithium anode in LiOH aqueous solution used for
Facile synthesis of Ag/AgVO3 hybrid nanorods with enhanced electrochemical performance as cathode ma
Thermodynamic description of the Ge-Na and Ge-K systems using the CALPHAD approach supported by firs
Investigation to impurity content and micromorphology of high purity titanium powder prepared by mol
Microstructures and mechanical properties of Fe-14Cr-3W-Ti-Y2O3 steel with 1 wt.% Cu addition fabric
Ideal mechanical strength and interface cohesion property of Ir-base superalloys from first principl
Effect of MWCNTs Additive on Desorption Properties of Zn(BH4)(2) Composite Prepared by Mechanical Al
Effects of Ca on microstructure, mechanical and corrosion properties and biocompatibility of Mg-Zn-C
Microstructural Evolution of a Nickel Ferrite-Copper Alloy Cermet During Sintering and High-Temperat
Innovative processing of high-strength and low-cost ferritic steels strengthened by Y-Ti-O nanoclust
Effect of tungsten content on microstructure and quasi-static tensile fracture characteristics of ra
Synthesis and characterization of superhydrophobic functionalized nanoparticle arrays on aluminum su
Preparation of Super-Hydrophobic Aluminum by a Novel Immersion Method using Potassium Permanganate S
Structural evolution and ablation mechanism of a hafnium carbide coating on a C/C composite in an ox
Experimental investigation and thermodynamic modeling of the Cu-Si-Zn system with the refined descri
THERMODYNAMIC MODELING OF THE Fe-Zn SYSTEM USING EXPONENTIAL TEMPERATURE DEPENDENCE FOR THE EXCESS G
Relationship between lamellar alpha evolution and flow behavior during isothermal deformation of Ti-
Effect of heat treatment on strength, exfoliation corrosion and electrochemical behavior of 7085 alu
First-principles calculations of binary Al compounds: Enthalpies of formation and elastic properties
Structure and thermodynamics of the key precipitated phases in the Al-Mg-Si alloys from first-princi
Development of an atomic mobility database for liquid phase in multicomponent Al alloys: focusing on
Fiber/matrix interfacial shear strength of C/C composites with PyC-TaC-PyC and PyC-SiC-TaC-PyC multi
Sol-hydrothermal synthesis and optical properties of Eu3+, Tb3+-codoped one-dimensional strontium ge
Flower-like hydroxyapatite modified carbon paste electrodes applicable for highly sensitive detectio
Comparison of microstructure and mechanical properties of Co-based and Fe-based alloy coatings depos
Thermodynamic assessment of the Ga-X (X=B, Ca, Sr, Ba) systems supported by first-principles calcula
Effect of heat treatment on hot deformation behavior and microstructure evolution of 7085 aluminum a
Ablation behavior of HfC protective coatings for carbon/carbon composites in an oxyacetylene combust
Effects of partial hydrogenation and vacancy defects on the electronic properties of metallic carbon
Effects of Cu and Al on the crystal structure and composition of eta (MgZn2) phase in over-aged Al-Z
Conversion of egg-shell to hydroxyapatite for highly sensitive detection of endocrine disruptor bisp
期刊信息
位置：