中文摘要：

利用高温度梯度定向凝固-液态金属冷却（LMC）技术制备了重型燃机定向结晶空心高压涡轮叶片,采用Pro CAST有限元模拟软件计算了LMC定向凝固工艺下,不同抽拉速率时空心定向结晶叶片凝固过程的温度场、晶粒组织以及一次枝晶间距（PDAS）,预测了抽拉速率对杂晶、雀斑等缺陷的影响.结果表明,模拟结果与实验结果吻合良好.随着抽拉速率增加,叶片的凝固速率、冷却速率均增加,远高于高速凝固法（HRS）的凝固速率、冷却速率;叶片不同部位达到最大纵向温度梯度时的抽拉速率不同,纵向温度梯度是评价定向工艺的有效方法;LMC工艺制备的燃机叶片消除了雀斑缺陷,PDAS远小于HRS工艺.

英文摘要：

Advanced aero and power generation industry needs high-performance gas turbine. As key parts of gas turbine directionally solidified（DS） columnar grain and single crystal（SX） blades operate in heavy stress and high temperature conditions. The continuous demand for increasing turbine inlet temperature and aggressive environment has pushed alloy designers to develop DS and SX Ni-based blade alloys that contain high amount of alloying elements. DS process of blades using such alloys has become a challenging task. The small DS and SX blades are usually produced by high rate solidification（HRS） process. However, the growth of large DS and SX blades requires directional solidification with a sustained thermal gradient along the DS direction. By increasing the thermal gradient, the dendrites are refined, which results in a mechanically-superior DS and SX with reduced defects. One method to achieve consistent and higher thermal gradients is the utilization of the liquid metal cooling（LMC） process. In this method, heat extraction from the outer surface of the mold during DS relies on heat conduction rather than radiation in the conventional HRS process. The optimization of the LMC process is difficult and costly by experimental methods, especially for the complexly shaped industry gas turbine（IGT） blades because of the complicated process parameters associated with the technique. Numerical simulation is an efficient method to solve this problem. In this work, directionally solidified industry gas turbine hollow blades were prepared by high gradient LMC process. Liquid Sn was used as cooling medium. The temperature fields, macrostructures, primary dendrite arm spacing（PDAS） at various withdrawal rates during LMC process have been calculated with Pro CAST software. The impact of withdrawal rate on formation of stray grains and freckles was predicted. The calculated results and the experimental observations agreed well. The solidification rates and cooling rates were found to increase with the increas