欢迎您！东篱公司
退出
-
申报数据库
-
立项数据库
-
成果数据库
-
项目获奖数据库
中文摘要：
采用Te溶剂-Bridgman法生长了尺寸为Ф30 mm×60 mm的Cd0.9Mn0.1Te∶In晶锭,通过淬火得到了生长界面形貌。测试了晶片在近红外波段的透过率和电阻;采用化学腐蚀的方法观察了晶片中位错,Te夹杂和孪晶界;采用光学显微镜和红外成像显微镜观察了生长界面处附近的形貌。测试结果表明,晶锭中部结晶质量较好的晶片红外透过率达到60%,电阻率达到2.828×1011Ω.cm。位错密度在106cm-2数量级,Te夹杂密度为1.9×104cm-2,同时孪晶密度明显低于Bridgman法生长的晶锭。生长界面宏观形貌平整,呈现微凹界面。但由于淬火过程的快速生长,界面微观形貌发生变化,呈现不规则界面,并在界面附近形成富Te相的包裹。
英文摘要：
Cd0.9Mn0.1Te∶In crystal ingot with size of Ф30 mm×60 mm was grown through Te solvent-Bridgman method.IR transmittance and resistivity were measured to evaluate its crystalline quality.Chemical etching was applied to reveal the crystal defects,including dislocations,twins and Te inclusions.The macro-and micro-morphology of growth interface were quenched and observed with optical microscopy and infrared transmission microscopy.Te solvent-Bridgman method could effectively decline growth temperature and reduce the dislocation density in the ingot.The IR transmittance of wafers in the middle of the ingot reaches 60% and the bulk resistivity reaches 2.828×1011 Ω·cm.The EPD of a good quality wafer is about 106 cm-2,Te inclusions density measured through IR transmission microscopy is about 1.9×104 cm-2comparing with conventional Bridgman growth method.The quenched growth interface shows a slightly concaved appearance in macro-scale.However,the micro-scale interface is not smooth due to fast growth in quenching process.Meanwhile high density of Te inclusion near the interface was observed.
同期刊论文项目
同项目期刊论文
Improvement of the quality of indium-doped CdZnTe single crystals by post-growth annealing for radia
Dependence of film texture on substrate and growth conditions for CdTe films deposited by close-spac
期刊信息
位置：