欢迎您！东篱公司
退出
-
申报数据库
-
立项数据库
-
成果数据库
-
项目获奖数据库
中文摘要：
通过金相组织观察、扫描电镜分析和室温拉伸力学性能及剥落腐蚀实验，分析探讨等温自由锻温度对7085铝合金显微组织、力学性能和剥落腐蚀的影响。研究结果表明：在370℃和400℃等温自由锻时，合金发生严重再结晶，强度较低，伸长率稍高，剥蚀抗力较差；在420℃锻造时，合金出现大量细小且分布均匀的亚晶粒，抗拉强度、屈服强度、伸长率和剥蚀抗力均较好，分别达到533．2MPa，495MPa，13．3％和EA。在450℃锻造时，该合金的晶粒开始长大，强度下降，伸长率稍有升高，剥蚀抗力较差。综合考虑显微组织、强度、塑性和剥落腐蚀等因素，确定420℃为合金等温自由锻最佳锻造温度。
英文摘要：
The microstructure, mechanical and corrosion property of 7085 aluminum alloy deformed at different isothermal free forging temperatures were analyzed using optical microscope （OM）, scanning electron microscope （SEM）, mechanical tensile test and exfoliation corrosion. The experimental results show that serious recrystallization occurs at 370 ℃ or 400 ℃, resulting in the strength severely decreases, the elongation increases slightly and exfoliation corrosion gets worse. At 420 ℃, the alloy exhibits small and uniform sub-grain structure, leading to better strength, elongation and exfoliation resistance. The ultimate strength, yield strength and elongation achieve 533.2 MPa, 495 MPa and 13.3%, respectively. Exfoliation corrosion grade reaches EA. While the deformation temperature rises 450 ℃, the grains begin to grow up. The strength and exfoliation resistance decrease, but the elongation increases slightly. Considering the factors of microstructure, strength, plastic and exfoliation resistance, 420 ℃ is determined to be the best isothermal free forging temperature.
同期刊论文项目
同项目期刊论文
Osteoblastic cell response on biphasic fluorhydroxyapatite/strontium-substituted hydroxyapatite coat
Synthesis and optical property of ultra-long alpha-Si3N4 nanowires under superatmospheric pressure c
A thermodynamic description of the Co-Cr-Ti ternary system over the entire composition and temperatu
Development of an atomic mobility database for disordered and ordered fcc phases in multicomponent A
Thermodynamic description of the Al-Mg-Si system using a new formulation for the temperature depende
Experimental Investigation and Computer Simulation of Gradient Zone Formation in WC-Ti(C,N)-TaC-NbC-
Photosan-II loaded hollow silica nanoparticles: Preparation and its effect in killing for QBC939 cel
Effect of calcium on the electrochemical behavior of lithium anode in LiOH aqueous solution used for
Facile synthesis of Ag/AgVO3 hybrid nanorods with enhanced electrochemical performance as cathode ma
Thermodynamic description of the Ge-Na and Ge-K systems using the CALPHAD approach supported by firs
Investigation to impurity content and micromorphology of high purity titanium powder prepared by mol
Microstructures and mechanical properties of Fe-14Cr-3W-Ti-Y2O3 steel with 1 wt.% Cu addition fabric
Ideal mechanical strength and interface cohesion property of Ir-base superalloys from first principl
Effect of MWCNTs Additive on Desorption Properties of Zn(BH4)(2) Composite Prepared by Mechanical Al
Effects of Ca on microstructure, mechanical and corrosion properties and biocompatibility of Mg-Zn-C
Microstructural Evolution of a Nickel Ferrite-Copper Alloy Cermet During Sintering and High-Temperat
Innovative processing of high-strength and low-cost ferritic steels strengthened by Y-Ti-O nanoclust
Effect of tungsten content on microstructure and quasi-static tensile fracture characteristics of ra
Synthesis and characterization of superhydrophobic functionalized nanoparticle arrays on aluminum su
Preparation of Super-Hydrophobic Aluminum by a Novel Immersion Method using Potassium Permanganate S
Structural evolution and ablation mechanism of a hafnium carbide coating on a C/C composite in an ox
Experimental investigation and thermodynamic modeling of the Cu-Si-Zn system with the refined descri
THERMODYNAMIC MODELING OF THE Fe-Zn SYSTEM USING EXPONENTIAL TEMPERATURE DEPENDENCE FOR THE EXCESS G
Relationship between lamellar alpha evolution and flow behavior during isothermal deformation of Ti-
Effect of heat treatment on strength, exfoliation corrosion and electrochemical behavior of 7085 alu
First-principles calculations of binary Al compounds: Enthalpies of formation and elastic properties
Structure and thermodynamics of the key precipitated phases in the Al-Mg-Si alloys from first-princi
Development of an atomic mobility database for liquid phase in multicomponent Al alloys: focusing on
Fiber/matrix interfacial shear strength of C/C composites with PyC-TaC-PyC and PyC-SiC-TaC-PyC multi
Sol-hydrothermal synthesis and optical properties of Eu3+, Tb3+-codoped one-dimensional strontium ge
Flower-like hydroxyapatite modified carbon paste electrodes applicable for highly sensitive detectio
Comparison of microstructure and mechanical properties of Co-based and Fe-based alloy coatings depos
Thermodynamic assessment of the Ga-X (X=B, Ca, Sr, Ba) systems supported by first-principles calcula
Effect of heat treatment on hot deformation behavior and microstructure evolution of 7085 aluminum a
Ablation behavior of HfC protective coatings for carbon/carbon composites in an oxyacetylene combust
Effects of partial hydrogenation and vacancy defects on the electronic properties of metallic carbon
Effects of Cu and Al on the crystal structure and composition of eta (MgZn2) phase in over-aged Al-Z
Conversion of egg-shell to hydroxyapatite for highly sensitive detection of endocrine disruptor bisp
期刊信息
位置：