应用二维离散元程序UDEC计算了地震荷载作用下边坡的位移,并将计算结果与Newmark法计算结果及震后现场实测值进行了对比.结果表明,Newmark法计算得到的位移值较实测值偏小,离散元计算得到的位移结果较Newmark法更接近于实测值.在此基础上,初步分析了地震荷载作用下坡高、坡角、岩层倾角等因素对顺层岩体边坡位移的影响规律.由分析结果可知,地震荷载下顺层岩体边坡的位移并不随坡高增加而单调增大,在坡高约100 m时位移达到最大值,坡高超高100 m位移反而有所降低;当坡高超高200 m后,位移随坡高的变化幅度不大,顺层岩体边坡的位移随坡角增加而单调增大.随岩层倾角增加边坡位移明显增大;当岩层倾角大于层面内摩擦角时,随着岩层倾角的增大,边坡变形增长幅度明显增大.
The displacements of two selected international landslide cases are calculated by two-dimensional program of UDEC and Newmark method, respectively. Comparison between the calculating results and the field values of earthquake induced displacements shows that the displacements calculated by Newmark method are lower than the field values and the displacements simulated by UDEC are close to the field values. Then, the influences of height and angle of bedding slope and angle of interface on displacement characteristics of bedding slopes under earthquake are analyzed. It is reported that the displacement doesn't monotonously increase with the increasing of H (height of bedding slope). It reaches max when H is about 100 m and then decreases with the increasing of H And when H is above 200m, its decreasing rate is small. It is also suggested that the displacement increases with the increasing of the angle of bedding slope. As well, the displacement increases with the increasing of β (angle of interface), and its increasing rate tended to obviously increase with the increasing of β at the condition of β larger than the friction angle of rock joint.