中文摘要：

传声损失是消声器结构设计和降噪性能分析评价的重要依据.基于有限元方法、以扩张腔消声器为例,分析计算了消声器内部声场,进行了传声损失的虚拟测量.对现有的三点法、传统的单边界四点法测量传声损失进行了模拟,探讨了尾管效应、尾端吸声系数、消声器上下游耦合效应对传声损失测量的影响,论述了需要采用消除上下游耦合效应的双边界条件四点法测量传声损失的必要性,并利用该算法对典型消声器进行传声损失测量,所得试验结果与理论结果及有限元分析结果具有良好的一致性.同时结合消声器内部声场的仿真结果,分析了传声器测点位置、传声器间隔等参数对传声损失测量精度的影响,给出了相应的传声器测点布置原则,对传声损失的实际测量提供了借鉴.

英文摘要：

Transmission loss （TL） is a key reference for structure design and noise reduction performance analysis of a muffler. Taken an expansion chamber muffler as an illustration, and based on finite elements method, the interior sound field of the muffler was calculated and analyzed, the transmission loss was virtually measured by three-point method and traditional four-point method under one load condition. Three-point method was to be calculated by measuring the complex sound pressure of two points upstream and one point downstream of the muffler pipe. It can only get the accurate results in the event that the muffler termination was ideal anechoic. Traditional four-point method under one load condition was to be calculated by measuring the complex sound pressure of two points upstream and two points downstream of the muffler pipe at the same time. Compared with three-point method, the transmitted reflected wave downstream from the actual tail pipe effects was taken into account in traditional four-point method, but its coupling effects on the wave upstream were ignored. And the measurement accuracy was obviously influenced by the sound absorption performance of the muffler termination. The lower the sound absorption coefficient of the termination, the worse is the measurement accuracy. So, exact results can not be achieved at low frequencies by adding sound absorption material at the muffler termination. On these bases, in order to eliminate the coupling effects on the wave upstream from the transmitted reflected wave downstream, four-point method under two load conditions was proposed. It calculates transmission loss by combining the complex sound pressure of two points upstream and two points downstream of the muffler pipe under two difference termination conditions, such as an open termination and a total reflection termination. Then the transmission loss of a typical expansion chamber was measured with this method. And the experimental result was well concordant with the theoretical and the finite elements a