欢迎您！东篱公司
退出
-
申报数据库
-
立项数据库
-
成果数据库
-
项目获奖数据库
中文摘要：
采用力学性能测试、光学显微镜、扫描电镜和透射电镜,研究热变形温度和淬火速率对7085铝合金组织和力学性能的影响。结果表明：随着热变形温度降低,再结晶体积分数显著增加,合金的力学性能先提高后降低;随着淬火速率的降低,晶界析出相粗化,晶界无沉淀析出带宽化,合金的力学性能降低。合金热变形温度越低,其淬火敏感性越高,这是由于在缓慢冷却的过程中,再结晶引起的大角度晶界和非共格的Al3Zr粒子成为MgZn2相的有利形核位置,降低合金的时效强化效应。
英文摘要：
The influences of hot deformation temperature and quench rate on microstructure and property of 7085 aluminum alloy were investigated by tensile testing,optical microscopy（OM）,scanning electron microscopy（SEM） and transmission electron microscopy（TEM）.The results show decreasing hot deformation temperature can greatly increase the volume fraction of recrystallization,and the mechanical properties firstly increase and then decrease.With the decrease of quenching rate,the size of precipitations coarsens and the width of precipitation free zone widens as well as the mechanical properties decrease.In addition,the lower the deformation temperatures are,the higher the quench sensitivity is,which is attributed to the large volume fraction of recrystallization resulting in a large amount of high angle grain boundaries and incoherent Al3Zr serve as the nucleation sites of η（MgZn2）.As a result,the aging-hardening decreases.
同期刊论文项目
同项目期刊论文
Osteoblastic cell response on biphasic fluorhydroxyapatite/strontium-substituted hydroxyapatite coat
Synthesis and optical property of ultra-long alpha-Si3N4 nanowires under superatmospheric pressure c
A thermodynamic description of the Co-Cr-Ti ternary system over the entire composition and temperatu
Development of an atomic mobility database for disordered and ordered fcc phases in multicomponent A
Thermodynamic description of the Al-Mg-Si system using a new formulation for the temperature depende
Experimental Investigation and Computer Simulation of Gradient Zone Formation in WC-Ti(C,N)-TaC-NbC-
Photosan-II loaded hollow silica nanoparticles: Preparation and its effect in killing for QBC939 cel
Effect of calcium on the electrochemical behavior of lithium anode in LiOH aqueous solution used for
Facile synthesis of Ag/AgVO3 hybrid nanorods with enhanced electrochemical performance as cathode ma
Thermodynamic description of the Ge-Na and Ge-K systems using the CALPHAD approach supported by firs
Investigation to impurity content and micromorphology of high purity titanium powder prepared by mol
Microstructures and mechanical properties of Fe-14Cr-3W-Ti-Y2O3 steel with 1 wt.% Cu addition fabric
Ideal mechanical strength and interface cohesion property of Ir-base superalloys from first principl
Effect of MWCNTs Additive on Desorption Properties of Zn(BH4)(2) Composite Prepared by Mechanical Al
Effects of Ca on microstructure, mechanical and corrosion properties and biocompatibility of Mg-Zn-C
Microstructural Evolution of a Nickel Ferrite-Copper Alloy Cermet During Sintering and High-Temperat
Innovative processing of high-strength and low-cost ferritic steels strengthened by Y-Ti-O nanoclust
Effect of tungsten content on microstructure and quasi-static tensile fracture characteristics of ra
Synthesis and characterization of superhydrophobic functionalized nanoparticle arrays on aluminum su
Preparation of Super-Hydrophobic Aluminum by a Novel Immersion Method using Potassium Permanganate S
Structural evolution and ablation mechanism of a hafnium carbide coating on a C/C composite in an ox
Experimental investigation and thermodynamic modeling of the Cu-Si-Zn system with the refined descri
THERMODYNAMIC MODELING OF THE Fe-Zn SYSTEM USING EXPONENTIAL TEMPERATURE DEPENDENCE FOR THE EXCESS G
Relationship between lamellar alpha evolution and flow behavior during isothermal deformation of Ti-
Effect of heat treatment on strength, exfoliation corrosion and electrochemical behavior of 7085 alu
First-principles calculations of binary Al compounds: Enthalpies of formation and elastic properties
Structure and thermodynamics of the key precipitated phases in the Al-Mg-Si alloys from first-princi
Development of an atomic mobility database for liquid phase in multicomponent Al alloys: focusing on
Fiber/matrix interfacial shear strength of C/C composites with PyC-TaC-PyC and PyC-SiC-TaC-PyC multi
Sol-hydrothermal synthesis and optical properties of Eu3+, Tb3+-codoped one-dimensional strontium ge
Flower-like hydroxyapatite modified carbon paste electrodes applicable for highly sensitive detectio
Comparison of microstructure and mechanical properties of Co-based and Fe-based alloy coatings depos
Thermodynamic assessment of the Ga-X (X=B, Ca, Sr, Ba) systems supported by first-principles calcula
Effect of heat treatment on hot deformation behavior and microstructure evolution of 7085 aluminum a
Ablation behavior of HfC protective coatings for carbon/carbon composites in an oxyacetylene combust
Effects of partial hydrogenation and vacancy defects on the electronic properties of metallic carbon
Effects of Cu and Al on the crystal structure and composition of eta (MgZn2) phase in over-aged Al-Z
Conversion of egg-shell to hydroxyapatite for highly sensitive detection of endocrine disruptor bisp
期刊信息
位置：