中文摘要：

本文采用格子Boltzmann方法对液滴撞击液膜过程进行了研究,主要考察了雷诺数（Re）、韦伯数（We）、相对液膜厚度（h）以及表面张力（σ）等物理参数对界面运动过程的影响.首先,随着Re数和We数的增加,可以明显观察到液滴撞击液膜过程中形成的皇冠状水花以及卷吸现象;当Re数较大时,液体会发生飞溅,由液体飞溅形成的小液滴则会继续下落,并与液膜再次发生碰撞.其次,当相对液膜厚度较小时,液滴撞击液膜并最终导致液膜断裂;然而随着相对液膜厚度的增大,尽管撞击过程溅起的液体会越来越多,但是液膜并不会发生断裂.再次,随着表面张力的增大,界面变形阻力增大,撞击过程中产生的界面形变也逐渐减弱.最后还发现皇冠（由液滴溅起形成）半径r随时间满足r/（2R）≈α√U t/（2R）,这一结果与已有结论是一致的.

英文摘要：

The process of the droplet impact onto the liquid film, as one of the basic multiphase problems, is very important in many fields of science and engineering. On the other hand, the problem is also very complicated since there are many parameters that may influence the process of the droplet impact on the liquid film. To clearly understand the physical phenomena appearing in the process droplet impact on the liquid film, a parametric study on this problem is conduced based on a recently developed lattice Boltzmann method in which a lattice Boltzmann model is used to solve the Navier-Stokes equations, and the other is adopted to solve the Cahn-Hilliard equation that is used to depict the interface between different phases. In this paper, we mainly focus on the effects of the Reynolds number（Re）, the Weber number（We）, the relative thickness of film（h） and the surface tension（σ） on the dynamic behavior of interface between different phases, and the velocity and pressure fields are also presented. It is found that with the increase of Re and We, the phenomena of crown and entrainment can be observed obviously during the process of droplet impact onto the liquid film, and the radius of the crown seems not dependent on the We and Re where the relative thickness of film and surface tension are fixed to be 0.5 and 0.003. However, when Re becomes much larger, the splashing phenomenon is produced, and the small droplets caused by the splashing can fall and then impact onto the liquid film again. We also find that if the relative thickness of film is small, the surface tension, Re and We are set to be 0.003, 480 and 500,the film can break up during the process of the droplet impact onto the liquid film, while with the increase of relative thickness, although more liquid are induced in the splashing process, the film can＇t break up. In addition, with the increase of surface tension, the resistance which prevents the change of interface becomes large, and thus the change of interface is not large when the dr