欢迎您！东篱公司
退出
-
申报数据库
-
立项数据库
-
成果数据库
-
项目获奖数据库
中文摘要：
在某200MW四角切圆燃烧煤粉炉上实施了三次风再燃技术,并采用现场试验和数值模拟相结合的方法,研究不同三次风带粉量工况下的炉内煤粉燃烧和NOx还原情况.研究结果表明,引入高速燃尽风喷口（OFA）射流可以强化混合,加快焦炭颗粒的燃尽,同时通过合理控制OFA喷口高度来避免炉膛上部超温;为降低飞灰含碳量,要尽量提高主燃区内煤粉的燃尽程度;若适当提高OFA喷口高度并合理控制炉内各区域的过量空气系数,在20%带粉量情况下,该三次风再燃方案可以获得50%以上的脱硝率并基本不影响锅炉正常运行.
英文摘要：
Tertiary air reburning technology was applied to a 200 MW tangentially coal-fired boiler,with using the micronized coal contained in the tertiary air as reburning fuel. In different conditions of the micronized coal content in the tertiary air,the coal combustion and NOx reduction were investigated by means of both field tests and numerical simulation. The results show that the high-velocity over fire air （OFA） injections can improve the mixing,and therefore make the char particles burn out quickly. Also the OFA nozzles should be located properly so as to avoid temperature increase in the upper furnace. In order to reduce the carbon content in fly ash,the coal burnout ratio in primary zone should be improved to a high level. The results also indicate that NOx reduction rate of more than 50% can be obtained without adverse impact on boiler performance with satisfying the following conditions：the OFA nozzles are shifted upward in a proper range,each zone in the furnace is operated at reasonable stoichiometry,and the micronized coal content in the tertiary air is increased to 20%.
同期刊论文项目
同项目期刊论文
Semi-analytical Monte Carlo simulation of laser-induced fluorescence propagation in an optically par
Simultaneous measurements of two-dimensional temperature and particle concentration distribution fro
A comparative study of optimization algorithms for low NOx combustion modification at a coal-fired u
A 3D numerical simulation of laser-induced incandescence of soot particles in coal combustion produc
Investigations into the ignition behaviors of pulverized coals and coal blends in a drop tube furnac
Experimental measurements of a gas-solid jet downstream of a fuel-rich/lean burner with a collision-
Simultaneous measurement of three-dimensional soot temperature and volume fraction fields in axisymm
Inverse radiation problem of temperature field in three-dimensional rectangular enclosure containing
Improvement of load-following capacity based on the flame radiation intensity signal in a power plan
Simulation study on reconstruction model of three-dimensional temperature distribution within visibl
Efficient inverse radiation analysis of temperature distribution in participating medium based on ba
Design and characteristics of refractive index sensor based on thinned and microstructure fiber Brag
Combining support vector regression and ant colony optimization to reduce NOx emissions in coal-fire
Reconstruction of soot temperature and volume fraction profiles of an asymmetric flame using stereos
期刊信息
位置：