欢迎您！东篱公司
退出
-
申报数据库
-
立项数据库
-
成果数据库
-
项目获奖数据库
中文摘要：
基于Navier-Stokes方程和流体流动的连续性方程,建立了浇注式供液方式下,考虑砂轮、工件表面粗糙度的砂轮/工件楔形区流体动压力数学模型.在平面磨床上进行了流体动压力的实验研究,结果表明,实验中测量的动压力值与相同条件下模型理论值基本吻合,理论模型可很好地预测粗糙表面间楔形区压力场的分布;考虑粗糙度的楔形区流体动压力的理论曲线是不光滑的;楔形区流体动压力随着砂轮速度的增加、最小间隙的减小而增大,最大压力峰值分布在砂轮、工件最小间隙区域,且在该区域压力梯度变化明显.
英文摘要：
Considering roughness of the wheel and workpiece, the hydrodynamic pressure model of wedge-like zone with flood delivery was established based on Navier-Stokes and continuity equations. Experimental study of the hydrodynamic pressure was conducted on the surface grinder, and the experimental results show that the experiment measured pressure values are consistent with the theoretical values of the model under the same conditions, and the model can well forecast hydrodynamic pressure distribution at wedge-like zone between rough surfaces. The theoretical curve of the hydrodynamic pressure of the wedge-like zone between rough surfaces is not smooth. The hydrodynamic pressure of the wedge-like zone is increased with the increase of the wheel speed and the reduction of the minimum gap and the peo~ pressure is generated just in the minimum clearance region in which the higher pressure gradient occurs.
同期刊论文项目
同项目期刊论文
The theoretical and experimental investigation into technological parameters of high-melting metal a
Analytical and experimental investigations into material removal mechanism of abrasive jet precision
Analysis of static and dynamic stiffness for coupled double-rotor spindle system of high speed grind
Evaluation of the dynamic characteristics of coupled double-rotor spindle system in high speed grind
Modeling and Experimental Investigation of Pressure Field in the Grinding Zone with Nanoparticle Jet
Investigation into Engineering Ceramics Grinding Mechanism and the Influential Factors of the Grindi
Modeling the operation of a common grinding wheel with nanoparticle jet flow minimal quantity lubric
Experimental Verification of Nano-Particle Jet Minimum Quantity Lubrication Effectiveness in Grindin
Simulation Study on Effect of Cutting Parameters and Cooling Mode on Bone-drilling Temperature Field
Experimental Evaluation of the Lubrication Performance of MoS2/CNT Nanofluid for Minimal Quantity Lu
Technological Investigation about Minimum Quantity Lubrication Grinding Metallic Material with Nanof
Investigation into the Formation Mechanism and Distribution Characteristics of Suspended Micropartic
Experimental Study on Generation Mechanism and Influencing Factors of Metal Machining Fluid Oil Mist
Investigation on the Grinding Temperature Field of Nano-ZrO2 Dental Ceramics with a Nanoparticle Jet
Modeling and Simulation of the Single Grain Grinding Process of the Nano-particle Jet Flow of Minima
Experimental research on the energy ratio coefficient and specific grinding energy in nanoparticle j
期刊信息
位置：