欢迎您！东篱公司
退出
-
申报数据库
-
立项数据库
-
成果数据库
-
项目获奖数据库
中文摘要：
基于低塑性、大高径比铝合金板材零件成形需求,提出了主动径向压力充液拉深新技术.通过数值模拟方法,对5A06铝合金球底筒形零件主动径向加压充液拉深成形过程进行了研究.采用基于LS-DY-NA3D内核的动态显示分析软件ETA/Dynaform5.5,根据成形工艺的特殊性,提出了液压载荷施加方法;依据球底零件变形时悬空区大小和曲率半径确定了合理的加载路径,并分析了主动径向压力和液室压力对零件成形过程和零件壁厚分布的影响,讨论了成形过程中出现的缺陷.研究结果表明,采用合理匹配的主动径向压力和液室压力加载路径,可有效地降低板料成形时的径向拉应力,抑制零件球底部的过度减薄,显著提高铝合金球底零件的拉深极限.
英文摘要：
To satisfy the forming need of low plasticity materials and large height - diameter ratio parts, a new process of hydrodynamic deep drawing （HDD） with independent radial hydraulic pressure was proposed. Aiming at 5A06 aluminum alloy cylindrical cup with a hemispherical bottom, HDD with independent radial hydraulic pressure was studied by means of numerical simulation. By employing the dynamic explicit analytical software ETA,/Dynaform based on LS -DYNA3D, and according to the forming process, a method to load hydraulic pressure was put forward. Based on the suspended region size and the curvature radius, the reasonable loading path was determined. And the effects of independent radial hydraulic pressure and liquid chamber pressure on the forming process and the sheet-thickness distribution were analyzed. The defects forming during forming process were discussed. The results indicated that the reasonable match between independent radial hydraulic pressure and liquid chamber pressure could reduce the radial tensile stress, restrain the serious thinning at the bottom of hemisphere and increase the drawing limitation of aluminum alloy cylindrical cup.
同期刊论文项目
同项目期刊论文
Deformation evolution mechanism during hydro-bulging of tailor-welded tube with dissimilar thickness
An experimental investigation into the formability of hydroforming 5A02 Al-tubes at elevated tempera
Effects of loading paths on hydro dynamic deep drawing with independent radial hydraulic pressure of
Numerical simulation of flat bottom cylindrical cup by hydrodynamic deep drawing with independent ra
PLASTIC DEFORMATION REGULARITY OF TAILOR-WELDED TUBE (TWT) WITH DISSIMILAR THICKNESS DURING HYDRO-BU
Deformation and defects in hydroforming of 5A06 aluminum alloy dome with controllable radial pressur
Research of metal flow during extrusion process under different friction conditions by deforming are
期刊信息
位置：