欢迎您！东篱公司
退出
-
申报数据库
-
立项数据库
-
成果数据库
-
项目获奖数据库
中文摘要：
通过显微硬度测试、力学性能测试、透射电镜分析等手段研究了Al-5.2Cu-0.4Mg-1.02Ag合金板材在欠时效、峰时效、过时效的力学性能和显微组织。结果表明：合金主要强化相是Ω相和θ′相,它们之间存在竞相析出与长大的关系。欠时效时出现大量细小的Ω相和少量的θ′相,尺寸约为15nm;峰时效时Ω相长大且θ′相增多,Ω相的体积分数达到最大值,尺寸约为40～60nm,θ′相的尺寸约为40nm;过时效Ω相体积分数有所减少而θ′相体积分数有所增加,θ′相尺寸约为70～100nm,且有部分θ′相转变为θ相。峰时效时合金的抗拉强度和屈服强度达到最大值,断后延伸率随时效时间的延长有下降的趋势。
英文摘要：
The microstructure and mechanical properties of Al-5.2Cu-0.4Mg-1.02Ag （ % , mass fraction） alloy plate during under-ageing, peak-ageing and over-ageing stages were investigated by means of microhardness test, mechanical property test and transmission electron microscope. The results showed that the main precipitated phases were Ω phase and θ′ phase which precipitated and grew ahemantly. A plenty of Ω phase and a small amount of θ′ phase were found in the under-aged alloy, both of which were about 15 nm. In peak-ageing, the number of θ′ phase increased and 12 phases grew up, in which the volume fraction of Ω phase increased. The size of Ω phase and θ′ phase was about 40 -60 nm, 40 nm, respectively. In subsequent over-ageing, the number of phase decreased and the number of θ′ phase increased which size was about 70 - 100 nm and part of θ′ phase transformed into θ phase. The maximum tensile strength and yield strength were gained at peak-ageing, in addition, the elongation decreased with the extension of ageing time.
同期刊论文项目
同项目期刊论文
Hot die forging process optimization of superalloy IN718 turbine disc using processing map and finit
Tensile deformation and fracture characteristics of delta-processed Inconel 718 alloy at elevated te
期刊信息
位置：