欢迎您！东篱公司
退出
-
申报数据库
-
立项数据库
-
成果数据库
-
项目获奖数据库
中文摘要：
为探索燃烧过程中热声不稳定的产生机理，搭建了黎开（Rijke）预混燃烧器热声不稳定研究试验台架，并进行了试验研究。Rijke预混燃烧器为直径40mm，管长1066mm的不锈钢圆管，下端封闭，上端开口；致密堇青石材质的多孔介质稳燃体位于燃烧器四分之一管长处，甲烷与空气的预混气体在稳燃体上方燃烧形成平面火焰作为加热热源。试验发现，化学当量比φ对Rijke预混燃烧器内热声不稳定的强度有重要的影响，维持Rijke预混燃烧器持续燃烧的下限极限化学当量比和上限极限化学当量比分别为0.63和1，75。另外，试验发现了预混燃烧器内热声不稳定的最大强度并非发生在φ=1.0时，而是在φ=1.30左右；并且当1.0≤φ≤1.5时，预混燃烧器内的热声不稳定均维持较高的强度。
英文摘要：
In order to probe into the mechanism of the excitation of thermoacoustic instability in the process of combustion, experimental setup was built to study the thermoacoustic phenomenon in the premixed Rijke combustor. A closed-open Rijke combustor with 40 mm in diameter and 1066 mm in length was used. The flame holder made of dense cordierite was installed in the quarter of the combustor. The premixed gas of methane and air was ignited just downstream of the flame holder to form a flat flame. Experimental results show that the equivalence ratio φ has a significant effect on the intensity of thermoacoustic instability. In order to sustain the combustion in the Rijke combustor, the inferior and superior limit of the equivalent ratio was 0.63 and 1.75 separately. The largest intensity of thermoacoustic instability occurrs when φ at about 1.30 other than 1.0. The intensity of thermoacoustic instability maintains at a relatively large level when φ at the range of 1.0-1.5.
同期刊论文项目
同项目期刊论文
Characteristics of acoustic behavior, combustion completeness and emissions in a Rijke-type combusto
Semi-analytical Monte Carlo simulation of laser-induced fluorescence propagation in an optically par
Simultaneous measurements of two-dimensional temperature and particle concentration distribution fro
A comparative study of optimization algorithms for low NOx combustion modification at a coal-fired u
A 3D numerical simulation of laser-induced incandescence of soot particles in coal combustion produc
Investigations into the ignition behaviors of pulverized coals and coal blends in a drop tube furnac
Experimental measurements of a gas-solid jet downstream of a fuel-rich/lean burner with a collision-
Simultaneous measurement of three-dimensional soot temperature and volume fraction fields in axisymm
Inverse radiation problem of temperature field in three-dimensional rectangular enclosure containing
Improvement of load-following capacity based on the flame radiation intensity signal in a power plan
Simulation study on reconstruction model of three-dimensional temperature distribution within visibl
Efficient inverse radiation analysis of temperature distribution in participating medium based on ba
Design and characteristics of refractive index sensor based on thinned and microstructure fiber Brag
Combining support vector regression and ant colony optimization to reduce NOx emissions in coal-fire
Reconstruction of soot temperature and volume fraction profiles of an asymmetric flame using stereos
期刊信息
位置：