欢迎您！东篱公司
退出
-
申报数据库
-
立项数据库
-
成果数据库
-
项目获奖数据库
中文摘要：
通过对注射成型和注压成型方法的Moldflow模拟仿真,结合两种成型方法的特点,对注射成型和注压成型方法生产超薄导光板的工艺条件和制品质量进行了详细的对比和分析.结果表明,注压成型制品所需的注射压力明显小于注射成型制品,注压成型可以节约能源;注压成型制品的残余应力和翘曲变形数值都小于注射成型的制品,注压成型能够增加制品生产的合格率,可以提高生产效率.
英文摘要：
Based on the injection molding and the injection compression molding method,the process condition analysis and the quality of the ultra-thin light guide plate were compared by Moldflow in this paper.The results showed that the injection pressure of the injection compression molding product was significantly less than that of the injection-molding method which can save energy.The residual stresses and warpage values of injection compression molding products were less than that of the injection molding products.With the injection compression method,the quality rate of production,and the production efficiency were improved.
同期刊论文项目
同项目期刊论文
An Investigation into the Influencing Factors for Polymer Melt at the Filling Stage in Micro Injecti
Analysis on high-field magnetic properties of aluminum substituted rare-earth iron garnet at low tem
Research of Optical Characteristics of Diffuser with Taper Microstructure by Micro Injection Molding
期刊信息
位置：