欢迎您！东篱公司
退出
-
申报数据库
-
立项数据库
-
成果数据库
-
项目获奖数据库
中文摘要：
为了研究数值模拟结果的准确性，使用计算流体动力学（CFD）软件Numeca，采用Spalart—All—maras（S—A）模型和shearstresstransport（SST）模型对某压比为1．5的亚声速离心压气机叶轮的性能进行了计算，并将4个不同截面上的速度分布等计算结果和实验数据进行了对比．结果表明：s—A模型和SST模型的计算结果几乎完全相同，误差小于1％；整体性能的模拟计算结果和实验值吻合较好，在设计工况点，误差在2％以内，在非设计工况点，误差也小于6％；不同截面上速度分布的计算结果和实验值相差较大，在轮毂附沂．帚女误善存20％寿右．存轮缘附沂．窨珏钋截而帚女误善高干100％。不能直宴反映轮缘附沂的流动情况．
英文摘要：
A subsonic centrifugal compressor impeller with splitter blades of 1.5 pres sure ratio was analyzed by CFD software of Numeca using SpalartAllmaras （SA） and shear stress transport （SST） models to study the accuracy of numerical simulation results. The measured results of the impeller and verifications of CFD at four sections were presented with respect to the velocity distribution, etc. Results show that the simulation results of S A and SST models are almost the same, with the difference less than 1%; In general, the numerical simulation agrees well with the experiment, the difference is less than 2% at de sign point and 6 % in offdesign condition. The difference of numerical simulation and experi ment results of velocity distribution is large in different cross sections. There are relatively big differences about 20% near hub and more than 100% near shroud, which can not truly reflect the flow condition near the shroud.
同期刊论文项目
同项目期刊论文
Study of Modeling Unsteady Blade Row Interaction in a Transonic Compressor Stage Part 1: Code Develo
期刊信息
位置：