欢迎您！东篱公司
退出
-
申报数据库
-
立项数据库
-
成果数据库
-
项目获奖数据库
中文摘要：
针对某台新建的采用多次引射分级燃烧技术的超临界350 MW机组W火焰锅炉,采用数值计算研究了三次风倾角分别为0°、10°、20°、30°时对炉内流动和燃烧的影响.结果表明：三次风倾角为0°和10°时,炉内流场偏斜,下炉膛利用率偏低,炉膛出口烟气温度及NOx排放质量浓度较高;当三次风倾角增至20°后,炉内流场趋于对称,气流下射深度大,炉膛出口烟气温度及NOx排放质量浓度较佳;进一步加大三次风倾角至30°时,气流下冲过深,对冷灰斗产生明显的冲刷且冷灰斗内温度较高.综合考虑炉内流场对称性、炉膛出口烟气温度和NOx排放,三次风倾角取20°为宜.
英文摘要：
For a newly built supercritical 350 MW unit with down-fired boiler applying multi-injection stag- ing combustion technology, the fluid flow and combustion characteristics inside the furnace were numerical- ly simulated,under conditions with the tertiary air declination angle of 0°, 10°, 20°, 30°. The results show that,with the tertiary air declination angle of 0° and 10°,a deflected flow field with low furnace room utili- zation efficiency was observed, accompanied by high levels of gas temperature and NO° emissions at the furnace outlet. As the tertiary air declination angle increased to 20°, the flow filed turned into a relatively symmetrical pattern with great flame penetration depth,and the aforementioned high NO. emission at the furnace outlet decreased apparently to acceptable levels. However, excessively increasing the tertiary air declination angle to 30° resulted in an excessively large downward flame penetration depth, with the down- ward coal/air flow washing over the hopper wall and high gas temperatures in the hopper zone. Compre- hensively considering the formation of symmetric combustion with low NO. emission and gas temperature at the furnace outlet,the optimal tertiary-air declination angle should be 20°.
同期刊论文项目
同项目期刊论文
patial discretization error in an artificial benchmark model of oblique laser incidence by finite vo
Analysis on capabilities of density-based solvers within Open FOAM to distinguish aerothermal variab
A Second Order Radiative Transfer Equation and Its Solution by Meshless Method with Application to S
Analysis on transient conjugate heat transfer in gap–cavity–gap structure heated by high speed airfl
Numerical simulation of infrared signature emitted by liquid rocket plume using wide band k-distribu
Effect of air temperature on combustion characteristics and NOx emissions from a 0.5 MW pulverized c
Experimental study of the impact of holes-typesuction on the flow characteristics in a high-load com
First-principles molecular dynamics study on temperature-dependent dielectric function of bulk 3C an
Temperature-dependent dielectric function of germanium in the UV-vis spectral range: A first-princip
Characterization of combustion and NOx emissions with respect to over-fire air damper opening in a d
Simulation of flow behavior of particles bycluster structure-dependent drag coefficient model for ch
An effective inversion algorithm for retrieving bimodal aerosol particle size distribution from spec
Study of topology and vortex structure in turbinecascades with tip clearance under differentincidenc
Effect of the anthracite ratio of blended coals on the combustion and NOx emission characteristics o
Experimental study on the characteristics of heat transfer and flow resistance in a turbulent pipe f
Evaluation on cold modeling flow field for a down-fired 600 MWe supercritical boiler with multi-inje
Modeling of a rotational supercavitating evaporator and geometrical characteristics of supercavity i
Annaland Martin van Sint．Hans Kuipers, Dongsheng Wen, Discrete particle modeling of granular tempera
A de？ciency problem of the least squares ？nite element method for solving radiative transfer in stro
Simulation of flow behavior of particles by cluster structure-dependent drag coefficient model for c
Aerodynamic characteristics within a cold small-scale model for a down-fired 350 MWe supercritical u
Numerical simulation of natural convection in a square enclosure filled with nanofluid using the two
Inner and Outer Secondary-Air Distance-Effect Study within a Cold Small-Scale Model of a New Down-Fi
New over-fire air arrangement and its air ratio optimization determined by aerodynamic characteristi
期刊信息
位置：